Results 1 to 5 of 5
  1. #1
    Supporting Freak mav204's Avatar
    Join Date
    07-05-2013
    Location
    Akron, Ohio
    Posts
    272

    JKS Quicker Disconnects

    I have the JKS Quicker Disconnects, all 4 bolts came lose over the past 3 years; the only way to tighten them is to put a screw driver on the pin hold and torque it down. In the process I broke my craftsman screw driver. What are you all using that is strong to get torqued down?

  2. #2
    Freak of Knowledge e-jeep's Avatar
    Join Date
    04-02-2012
    Location
    Maryland
    Posts
    3,387
    Try some loctite
    Want Jeep Mods? Marcus Has Them!! ~ River City Offroad

    Adrenaline Offroad ~ Best Jeep shop in the Washington DC area!!

  3. #3
    Supporting Freak mav204's Avatar
    Join Date
    07-05-2013
    Location
    Akron, Ohio
    Posts
    272
    I did use red loctite, I am looking for recommendations on how to torque down on the nut without spinning the where to disconnect attaches to

  4. #4
    No one special ShutterBug's Avatar
    Join Date
    09-08-2013
    Location
    Cleveland, OH
    Posts
    2,641
    Post a picture.

    2014 Black JK Sport-icon - My "Lil' Mule"
    JCR Offroad | Rock Krawler | Barnes 4WD | Artec | RCV | Ten Factory
    My Build Thread

  5. #5
    Supporting Freak bradm's Avatar
    Join Date
    05-04-2012
    Location
    Delaware, Ohio
    Posts
    1,108
    Alignment punch, maybe? Probably stronger than a screwdriver

    Sent from my Galaxy S7 using TapaTalk
    2011 Black Sahara Unlimited
    4" FrankenLift
    37" MTR/Ks on black 17" ProComps
    DIY Hydro-Assist Steering
    Rubicon front axle with Yukon 5.13's
    Rear Eaton E-Locker with Yukon 5.13's

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •